ENGINEERING / FLOW ANALYSIS
A Moldflow report should show decisions, not only colorful plots.
Flow analysis is useful when it changes a gate, runner, cooling, wall or process decision. The report should state the assumptions, outputs, risks and recommended action in a way the buyer and toolmaker can use.
ABERY engineering note
Updated November 20, 2026
A simulation is not a guarantee. It is an engineering model that must be checked against the part, material data and trial result.
QUICK ANSWER
Require the mesh and material assumptions, gate and runner setup, fill/pack/cooling scenarios, output criteria, unresolved risks and a decision log. The report should explain what changed because of the analysis—not just show a fill animation.
1. Check the model assumptions.
The part geometry, wall thickness, material grade, gate location, runner size, cooling layout and process settings should be identified. A generic “ABS” or “PA66” material model may not represent the approved grade.
If the analysis uses a simplified runner, missing inserts, ignored slides or an assumed packing profile, state the limitation and the effect on the conclusion.
- Part revision and mesh quality.
- Exact resin grade and filler.
- Gate, runner and hot-runner assumptions.
- Cooling circuit and insert representation.
- Fill/pack profiles and boundary conditions.
- Known model limitations.
2. Review the engineering outputs.
Useful outputs may include fill time, pressure at transfer, temperature at flow front, shear rate, air traps, weld-line location, packing pressure, cooling time, temperature difference, volumetric shrinkage and warpage trend.
The interpretation matters more than the number of plots. Ask which outputs violated the agreed criteria and what decision was recommended.
| Fill | Pressure, flow front, short-shot risk and weld-line location. |
|---|---|
| Pack | Pressure transfer, gate freeze and shrinkage trend. |
| Cooling | Temperature difference and hot-spot risk. |
| Warpage | Predicted direction and sensitivity to assumptions. |
| Manufacturing | Gate, runner, vent and tool-access implications. |
| Action | What changed in design, tool or process. |
3. Compare prediction with T1.
The T1 report should identify the analysis case used, actual material lot, process settings and observed result. If the prediction and result differ, determine whether the difference comes from material data, geometry, process or model assumptions.
A good analysis creates learning. It should not disappear after the DFM meeting.
Make the report actionable.
Tie every recommended change to a design or tool decision and an owner.
Review DFM & Moldflow4. What to send to the analyst.
Send the final or clearly marked CAD, drawing, resin grade, volume, mold concept, gate options, cooling constraints, press data and quality concerns. State the decision the analysis must support.
If the purpose is warpage reduction, the report should include the assembly and measurement condition, not only the predicted displacement plot.
- 3D and 2D part definition.
- Exact resin grade and filler.
- Gate and runner alternatives.
- Cooling and insert constraints.
- Press and process window.
- Critical dimensions and acceptance condition.
Questions buyers ask before approving this scope.
Is Moldflow required for every injection mold?
Can Moldflow guarantee no warpage?
What is the most important part of a Moldflow report?
Should the molder use the same material model as the resin supplier?
Need a project-specific answer?
Send the part, material, volume and stage. We will identify what can be confirmed before quotation or tooling.
Send the projectContinue the engineering review.
Keep the scope comparable.
The linked guides are written to support a project-specific supplier and tooling review.
PROJECT INTAKE / FLOW ANALYSIS
Use analysis to make a better tooling decision.
Share the part, resin, gate concept and critical risk. We can identify the analysis questions that should be answered before steel is cut.
Tell us where the project is now.
Send the files and context you have. Missing information can be confirmed during review.
Business inquiries only. For large files, include a secure Google Drive, Dropbox, OneDrive or WeTransfer link, or email tonney@a-mold.com after submitting.